Minimum Time Step Average Time Step Maximum Time Step
Minimum Time Step (sec) 0.984
Average Time Step (sec) 9.071
Maximum Time Step (sec) 30.000
Percent in Steady State (%) 0.000
Average Iterations per Time Step 4.821
Use a maximum time that will lower your average iterations per time step to speed up the simulation,decrease the maximum time step to lower the number of iterations, use equivalent conduit lengthening to increase the minimum time step, the model is fastest if the minimum and maximum time steps are not too small or large compared to the average time step. Adjust the stopping tolerance and the number of iterations if you can to speed up your model You can also decrease the number of iterations or the stopping tolerance to speed up the model or improve the continuity error of themodel. If you are doing a continuous simulation then you can have a reduced graphical output data set to speedup the simulation
|
Autodesk Technologist with Information about Stormwater Management Model (SWMM) for watershed water quality, hydrology and hydraulics modelers (Note this blog is not associated with the EPA). You will find Blog Posts on the Subjects of SWMM5, ICM SWMM, ICM InfoWorks, InfoSWMM and InfoSewer.
Friday, November 4, 2011
Three Hidden Secrets to Speeding up your SWMM 5, H2OMAP SWMM or InfoSWMM Model
Subscribe to:
Post Comments (Atom)
Today is day 356 or 97.5 percent of the year 2024
English: Today is day 356 or 97.5 percent of the year 2024 Mandarin Chinese: 今天是2024年的第356天,即97.5% Hindi: आज 2024 का 356वां दिन या 97.5 प्रत...
-
@Innovyze User forum where you can ask questions about our Water and Wastewater Products http://t.co/dwgCOo3fSP pic.twitter.com/R0QKG2dv...
-
Subject: Detention Basin Basics in SWMM 5 What are the basic elements of a detention pond in SWMM 5? They are common in our back...
-
Soffit Level ( pipe technology ) The top point of the inside open section of a pipe or box conduit. The soffit is the ...
No comments:
Post a Comment